Biomedical Waste Autoclave

Labtronixed Inc is a biomedical waste autoclave manufacturer in India and has long years of experience in designing, fabrication and installation of such autoclaves throughout India. Depending upon daily waste sterilization capacity, we can design the suitable sterilizer. If you are not sure which capacity you need for medical waste autoclave or suitable for your plant., we can evaluate equipment requirements to fulfil needs; in addition, we can evaluate equipment requirements to fulfil needs; in addition, we offer to you demo and how to operate the autoclave at our factory.

We also provide fully automated biomedical waste autoclave sterilizer with 150 liters to 3000 liters. Our Autoclave Controller is touch screen HMI control programs system with data logging.

Features

• Equipment with pressure gauge, safety valve and steam release valve.
• Equipment with plug screen to prevent the discharge line from choking.
• Drain valve is fitted at the side bottom for easy draining/cleaning.
• Sterilizing Temperature up to 134°C.
• Sterilizing pressure : 1.2 to 1.5 kg/cm2 (15 psi to 22psi).
• Hydraulically Tested up to 40 psi.
• Fitted with Digital Temperature Indicator.
• Advanced control system with touch pad control
• High volume water-ring vacuum-pump for fast and efficient air removal
• Stand-by heating mode keeps the autoclave warm and ready for use
• Built-in alpha-numeric printer
• Mounted on wheels for easy mobility and sterilization on demand
• Pre-vacuum air stream sterilization
• Control panel fitted with Pressure control switch, Main switch, Pilot lamps, relays etc. and mounted on the stand of the sterilizer for easy operation.
• Voltage: 440 volts, 3 phase A. C. Supply

Technical Specification 

Construction

• These Sterilizers work on the principle of downward displacement of air which is the most economical method of obtaining sterilization.
• Triple walled with inner chamber and separate boiler is made up of Heavy gauge non magnetic S.S. Sheet (304/316 grade) argon-arc welded and jacket is made out of rolled steel.
• Boiler Made of thick stainless steel fitted under the sterilizer. High grade flanged type heating elements are fitted from front side for easy replacement/repair. Fitted with water gauge glass for water level, safety valve, water inlet and drain valves provided with Low Water Level cut off device.
• Whole unit horizontally mounted on a sturdy, heavy M.S. duly painted or Stainless steel tubular stand.
• Lid (single piece door) made out of rolled steel lined with S.S. sheet on both sides tightened by Radial Locking System which cannot be opened when under pressure. The self-locking device automatically disengages the thread mechanism when the sterilizer is under pressure to preclude any eventuality of accident.
• Sealing of Lid by Neoprene Rubber Gasket.
• Fitted with shelf locking safety device.
• Sterilization cycle is controlled by single point multi port valve fitted at front top. Pressure gauges are fitted to read jacket & chamber pressure on the top A moisture trap is fitted in the chamber discharge line to absorb the condensate automatically to prevent moistening in the chamber.
• Chamber Insulated by Mineral/Glass Wool to minimize the heat losses and is covered by polished stainless steel sheet.